Thanks for stopping in, I hope you find a few items that interest you. I will try and give a decent picture description of each item so you will know what to expect. Also please note there is a $10.00 minimum order. Orders will be taken by email only, If your located anywhere other than the lower 48 states. Email me first to discuss shipping options. Orders will be shipped as a rule on Fridays only.
contact : [email protected] Customer Feedback
1:32 Engines
$5.25 each
All engines will include multiple parts, and will require assembly and paint.
1:32 Busts, Full Driver Figure, Driver Heads
Heads
.50 each
M/T Racing Motors
These are not surplus motors, they were ordered with these specific settings.
All motors will be tested with a 12 volt power source to insure a operating unit is shipped.
M/T -1
S CAN
M o d e l N u m b e r FC-130
Carbon Brushes
Dual Shaft 7.7mm can end, 7.7mm end bell end
Testing results
13,523 RPMs @ 12 volts 101 gcm @12 volts, 3.3 watts @12 volts
In Stock
$7.50 each
M/T-SL1
SLIM CAN
Model number FF-050
Testing results
13,465 RPM - 13,805 RPM
In Stock
$7.50 each
M/T-SL2
SLIM CAN
Model number FF-050
Testing results
18,161 RPM CW, and 17,944 RPM CCW @12 volts 74 gcm @ 12 volts, 2.5 watts @ 12 volts
In Stock
$7.50 each
M/T -5
LONG CAN
Model number FF-180
Carbon Brushes
Testing results
15,450 RPMs @ 12 volts, 240gcm @ 12 volts, 10.2 watts @ 12 volts
$9.50 each
Stainless steel tubing
Press fit, but loctite is advised on the motor shaft end.
1.5mm inside diameter x 2mm outside diameter
Great for making drive shafts for those slim-line motors. Or can be used to adapt a standard 2mm pinion to a slim-line motor shaft.
2" piece
$1.75 each
Modeling Supplies